Chapter 6 Other Features
6.1 Averaging Feature
When measured values are unstable, they can be stabilised using averaging. The number of times
averaging is conducted can be selected from four, eight, or sixteen times. When using this averaging
feature, icon is displayed on the screen. This feature is turned off under initial settings and
after resetting the system.
Press key to display the current number of times used for averaging. Keep this key de-pressed
to switch the number of times set.
After approximately one second passes with no settings made, the settings displayed will be entered
and the instrument will return to the measurement screen.
The averaging feature is conducted for resistance values.
The averaging feature can be used to change the rate of updating display of measured
values.
When not using the averaging feature, select ‘OFF”.
6.2 Auto-Hold Feature
This feature can be used to recognise automatically the stability of measured values and to hold
measured values.
Configuring the Auto-hold Feature
Press the key several times to display the icon.
To Next Page
Loading...
