7.4.8 Deleting Data from the 3554’s Internal Memory
The application can be used to read measurement data saved to the instrument’s internal memory.
1. Click [Read/Delete Data] on the initialisation screen.
2. Click [Delete Data].
3. Click all numbers of the unit to delete.
Click [ALL UNITs] to delete all units.
If no data has been saved to the instrument’s internal memory, the unit numbers will be
covered in a mesh-like pattern and will not be available for choosing.
4. Click [OK].
Data deletion will begin.
Click [Cancel] to return to the previous screen.
Deletion of a single unit (400 units of data) takes approx. 0.5 seconds).
Transfer of all units (4800 units of data) takes approx. three seconds.
To Next Page
Loading...
