4. Select the directory to which to save the read data, enter a filename and then click [OK’.
Data transfer will begin.
Transfer of a single unit (400 units of data) takes approx. eight seconds.
Transfer of all units (4800 units of data) takes approx. 90 seconds.
The transfer times given are approximations. The actual time needed may vary
depending on the processing speed of the computer used.
5. When transfer is complete, the following dialog box will appear. Click [OK].
6. To open the read data, open the file in the directory designated in step 4.
In this way, the data read from the instrument can be checked.
To Next Page
Loading...
