4. Pull off the connector and remove the pin.
5. Fasten a new pin. Press the tip of the pin against a hard board so that the pin won’t spring
out, and push the connector onto the pin.
6. Assemble the pin type lead in the reverse order of disassembling.
Do not pull or twist the cable.
7. Toa void broken wires and contact failures, after tightening the cable lock, gently tug and
twist the cable to check it is firmly held.
8. Check the performance. Measure an object with a known resistance. Make sure that the
measured resistance is correct before using the pin type lead.
9.6 Cleaning
To clean the instrument, wipe it gently with a soft cloth moistened with water or mild detergent.
Never use solvents such as benzene, alcohol, acetone, ether, ketones, thinners or gasoline, as they
can deform and discolour the case.
9.7 Discarding the Instrument
When disposing of this instrument, remove the lithium battery and dispose of
battery and instrument in accordance with local regulations.
To avoid electrocution, turn off the power switch and disconnect the test lead
before removing the lithium battery.
To Next Page
Loading...
