Hioki 3554 - 3.3 Zero-adjustment

Industrial Batteries & Energy Storage
1300 734 253
sales@regalelectro.com.au
www.regalelectro.com.au
3. When pressing the PRESS button on the 9466 Remote Control Switch, the measured values
will be held. When pressing the button again, the data will be saved to the selected memory
no.
4. The hold feature will be turned off.
Be sure not to insert or remove the mini-plug while the test lead is connected to the
battery subject to measurement. Connect the handy switch only after disconnecting
the test lead from the battery.
Do not insert the mini-plug of the 9466 Remote Control Switch into the TEMP.SENSOR
terminal.
5.3 Turning off the Memory Feature
To turn off the memory feature when it is on, hold key down for two seconds or longer.
‘OFF’ will be displayed, and the screen will return to the normal mode.
5.4 Reading Saved Data
Saved measured values can be read and displayed.
1. Press key.
This will display the reading screen.
2. Press keys to select the memory no.
Press keys to select digits.
The measurement values for the selected memory no. will be
displayed.