Hioki 3554 - Page 40

Industrial Batteries & Energy Storage
1300 734 253
sales@regalelectro.com.au
www.regalelectro.com.au
Measure Value: FAIL
Comparator Comparison Table
Judgement is conducted using the display and the buzzer, as shown in the following table:
Resistance Upper
Limit No.1
Resistance upper Limit
No.2
Resistance (Low)
Resistance
(Medium)
Resistance (High)
Voltage
Lower Limit
Voltage (High)
PASS
WARN
FAIL
Voltage (Low)
WARN
WARN
FAIL
Boundary conditions are shown below:
Resistance
PASS
≤
Resistance
upper limit
no.1
<
Resistance
WARN
≤
Resistance
upper limit
no.2
<
Resistance
FAIL
Voltage WARN
<
Voltage Lower Limit
≤
Voltage PASS
Examples of How to Read the Comparator Output Table
Example 1
When the measured resistance value does not exceed resistance upper limit no.1
and the measured voltage value is greater than the voltage lower limit, ‘Pass’ will be
displayed.
Example 2
When the measured resistance value exceeds the resistance upper limit no.1 and
does not exceed the resistance upper limit no.2, and the measured voltage value is
greater than the voltage lower limit, ‘Warning’ will be displayed and a buzzer
sounded.