94
Wireless Communications Function
• At the time of initial startup (with no device registered), GENNECT
Cross starts up with the Instrument Settings screen.
• When the instrument is nearby, it is automatically connected and
registered in the connection setting screen (up to 8 devices).
• Wait for 5 to 30 seconds for the instrument to be connected and
registered after turning on the power to the instrument. If the
instrument is not registered after 1 minute, restart GENNECT Cross
and the instrument.
5
Select a function and perform measurement.
Event recording function (EVENT)
The event recording function logs the data when measured values
exceed a desired threshold value, which can be set with GENNECT
Cross. For details, see the Help function in GENNECT Cross. The
number of recorded events can be checked on the instrument.
Press for at least
1 second.
Number of events
displayed
An event with a duration time of less than 200 ms may not be
accurately measured, failing to detect the event.
The instrument can record up to 99 events. The event recording will
terminate when the recorded events reach 99 in number.
When you start another event recording session, the instrument will
delete previously recorded data.
To Next Page
Loading...
