EasyManua.ls Logo

Hirobo jm2-0307903 - Before Using the Unit; For the Safe Operation of Electric Models

Hirobo jm2-0307903
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
6
注意 CAUTION
送信機、乾電池、バッテリー、充電器、機体等を幼児や子供の手の
届くところに放置しないでください。
さわって作動させたり、電池をなめたり、小さな部品を口にいれた
りすると、ケガや化学物質による被害を受ける可能性があります。
本書で指定した箇所以外の分解、改造を行わないでください。
感電、ケガ、機器の故障やそれに伴う火災の原因になります。
送信機、バッテリー、充電器、機体を次のような場所に保管しない
でください。
このような場所に保管すると変形や故障、機器の故障に伴う火事や
ケガの原因となります。
40℃以上になる暑いところ、-10℃以下になる寒いところ。
・直射日光があたるところ。
・湿気、振動、ほこりの多いところ。
・水分や蒸気、熱が当たるところ。
次のような場所では飛行させないでください。
1. 水気のある場所
防砂・防水対策が行われていません。装置内部に砂や水が入ると
誤動作して墜落したり、故障の原因になります。
2. 他のラジコン飛行場の近く(3km 程度以内)や高圧線・通信施設の
近く電波の混信などにより墜落したり、万一プロポや機体の故障
により墜落した場合、衝突によるケガや物損の原因になります。
同じ周波数の機体を同時に飛行させないでください。電波が混信し
て墜落します。
変調方式(AM, FM, PCM方式など)が違っていても周波数が同じ場
合は混信します。
使用中使用直後には機体に搭載さていモーー、ギヤ
スピードコントローラーには触れないでください。
高温になっているためヤケドします。
雑し( 、ペ ) くだ
たり改 たりでくださ となり
回転分に手や顔づけいでい。思わガの恐れが
危険回避本製品や床姿勢で操作
ときに早く移るように 作しましう。
送信機放す時はず機体送信機のOFF くだ
イッ ONのまま、 するとステック
の原因恐れがあます
回転部分や電気にる事故の危険があ子様には絶
使 くだ
本製品は精密機器誤使用や落下す。
性能維持取扱説明書読み安全使いい。
、使
小さいもの のもの
使 、小
ガなしない十分万一、お子様が飲み込ん
ちに師と相談しださい。また、入ってい
手の届かい所に捨て
なく変する あり
Never leave equipment such as the transmitter, dry battery, battery, charger
or flying unit in a location that can be accessed by the inquisitive hands of
infants or children.
They can accidentally activate operation, or put the battery or small parts in
their mouth; any of such actions could result in injury or damage caused by
chemical substance.
Never disassemble or attempt to modify anything other that what is
specified by this manual.
Doing so could cause electric shock, an injury, equipment breakdown or a
subsequent fire.
Never store the transmitter, battery, charger, or flying unit in the following
places. Storing such equipment in these places could cause shape distortion,
breakdown and
subsequent injury or fire as a direct result of equipment breakdown.
Hot places that exceed 40 C or cold places that fall below -10 C
Places exposed to direct sunlight
Places with high humidity, vibration, or lots of dust
Places with moisture or steam or where exposed to a source of heat
Never fly this product in the following places.
1. Places where there is moisture
This product does not have any protection against grit or water. If grit
(sand dirt, etc.) or water were to penetrate the inner part of the unit, it
would cause faulty operation, a crash or breakdown.
2. Close to other flying fields for radio controlled aircraft (3 km radius) or
close to high voltage lines or communications installations
This will cause a crash due to signal interference, if a crash occurs due to
breakdown of the flying unit or transmitter, the collision could cause an
injury or some kind of property damage.
Always refrain from flying units that use the same radio frequency at the
same time. The radio signal interference will cause a crash.
* The radio signal interference will still happen when the radio frequency is
the same even if a different modulation type is used (AM, FM, PCM etc).
Always refrain from touching parts that are installed in the flying unit,
namely the motor, pinion gears and speed controller during use or directly
after use.
These parts heat up to high temperatures and can cause burns.
Never fly in a place cluttered with obstacles (near buildings, people, pets,
etc.).
Never disassemble or attempt to modify the product. It will cause a
breakdown.
Never put hands or face close to rotating parts. Doing so creates the risk of
unexpected injury.
To avoid such risk, never operate this product while sitting on the floor or
on a chair. Operate this product in a posture that allows you to quickly get
out of the way if necessary.
Always switch off both the flying unit and transmitter when leaving the
transmitter unattended.
If the power switch is left on, it is possible that unintended stick operation
causes accidents.
Never allow young children to use this product due to the risk of accidents
or injuries caused by contact with rotating parts, short circuits, or electric
shocks, etc.
Always use this product in a way that is proper and safe to maintain its
performance. To do this you must read this instruction manual thoroughly.
This product is a precision machine that can easily be broken if dropped or
used incorrectly.
Never use parts that are damaged or have altered shape in this product to
ensure safe practice.
Always pay attention to the fact that much functionality is required of this
product's parts andparts include small items, sharp items and items made
from metal. Prevent any possibility of a small child putting these parts in
their mouth or getting injured by these parts. If a child swallows a part, seek
urgent medical advice. Always discard the packaging of the parts in a place
out of reach of children.
The cost, specifications and dimensions of products can change without
prior notification.
ご使用の前に Before using the unit
For the safe operation of electric models
電動模型の安全
警告 WARNING

Table of Contents

Related product manuals