Switching
[ Switching > L2-Redundancy > Link Aggregation ]
218
RM GUI GRS
Release
8.0
09/2019
Possible values:
1
(default setting)
2
Depending on the hardware:
4
8
32
Type
Displays whether the LAG interface is based on the
Static link aggregation
function or on LACP.
Possible values:
static
The LAG interface is based on the
Static link aggregation
function.
dynamic
The LAG interface is based on LACP.
Send trap (Link up/down)
Activates/deactivates the sending of SNMP traps when the device detects changes in the link up/
down status for this interface.
Possible values:
marked
(default setting)
The sending of SNMP traps is active.
If the device detects a link up/down status change, then the device sends an SNMP trap.
unmarked
The sending of SNMP traps is inactive.
The prerequisite for sending SNMP traps is that you enable the function in the
Diagnostics > Status
Configuration > Alarms (Traps)
dialog and specify at least 1 trap destination.
LACP admin key
Specifies the LAG interface key. The device uses this key to identify the ports that can be
aggregated to the LAG interface.
Possible values:
0..65535
You specify the corresponding value for the physical ports in the
LACP port actor admin key
column.
Port
Displays the physical ports number assigned to the LAG interface.
Aggregation port status
Displays whether the LAG interface aggregates the physical port.
To Next Page
Loading...
