Hirschmann GREYHOUND GRS1020 - Page 288

Diagnostics
[ Diagnostics > Ports > Auto-Disable ]
287
RM GUI GRS
Release
8.0 09/2019
[Status]
This tab displays the monitored parameters for which the Auto-Disable function is activated.
Table
Reason
Displays the parameters that the device monitors.
Mark the adjacent checkbox so that the Auto-Disable function disables and, when applicable,
enables the port again if the monitored parameters are exceeded.
Category
Displays which function the adjacent parameter belongs to.
Possible values:
 port-monitor
The parameter belongs to the Port Monitor function. See the Diagnostics > Port > Port Monitor
dialog.
 network-security
The parameter belongs to the functions in the Network Security menu.
 l2-redundancy
The parameter belongs to the L2-Redundancy functions. See the Switching > L2-Redundancy
dialog.
Auto-disable
Displays whether the Auto-Disable function is activated/deactivated for the adjacent parameter.
Possible values:
 marked
The Auto-Disable function for the adjacent parameters is active.
The Auto-Disable function disables and, when applicable, enables the relevant port again if the
monitored parameters are exceeded.
 unmarked (default setting)
The Auto-Disable function for the adjacent parameters is inactive.