Hitachi CB 520H B1 - Confirming Switch Mode of FC Switch Module

Confirming switch mode of FC switch module
To confirm the switch mode
1. Click Start > Programs > Accessories > Communications >
HyperTerminal to boot up terminal software.
2. The Connection Description window is displayed. Enter telnet1, and
then click OK.
3. Select TCP/IP (Winsock), enter < IP address > in the Host address
box, and then click OK.
< IP address >:IP address for the target switch module. See Internal IP
address setup procedure for switch module on page 4-18 section.
4. The login prompt is displayed in the terminal.
Figure 4-27 Connecting to FC switch module
5. Enter admin as login name, and then press Enter key.
6. Enter password as password, and then press Enter key.
Common process for replacement
4-25
Hitachi Compute Blade 500 Series System Service Manual