Figure 5-76 Removing the mezzanine card- storage expansion blade
Installing a mezzanine card
1. Put on an anti-static wrist strap.
2. If the connector cover is installed in the slot where you want to install the
spare mezzanine card, remove the cover from the slot first.
Figure 5-77 Removing the connector cover
3. Align the three alignment holes of mezzanine card with the guide pins, as
shown below.
4. Reverse the removal procedure.
5. Configure the parameters in the case of replacing Emulex HBA card.
See
Configuration procedure for Emulex HBA card on page 7-2 section.
6. Perform Installing a storage expansion blade on page 5-12 procedure.
Replacing parts
5-63
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
