Figure 5-15 Removing a server blade from the storage expansion
blade
9. Lift up the enclosure of the server blade.
Figure 5-16 Removing a server blade from the storage expansion
blade
Installing a server blade with a storage expansion blade
1. Put on an anti-static wrist strap.
2. Align the server blade onto the position indicated with blue circles in the
following figure, and then put the server on expansion blade.
3. Slide the server blade toward the expansion blade until it fixes.
(Confirm that the server blade does not slide toward opposite side.)
4. Open the top cover of the server blade. See
Opening a top cover, Server
blade on page 5-38 section.
Figure 5-17 Installing a server blade on the storage expansion
blade
Replacing parts
5-19
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
