Go to Rebooting the server before restoring FCoE settings on page
7-94. And go to Restoring FCoE settings on page 7-95.
c. The server model is CB 520H A1/B1, CB 520A A1, or CB 540A A1/B1,
the management module firmware version is A0180 or later:
Server model Firmware version
CB 520H A1/B1 01-70 or later
CB 520A A1 02-38 or later
CB 540A A1/B1 03-20 or later
Go to Restoring the UMC and Personality settings on page 7-90.
d. The server model is CB 520H A1/B1, CB 520A A1, or CB 540A A1/B1,
the management module firmware version is A0179 or earlier:
Server model Firmware version
CB 520H A1/B1 01-69 or earlier
CB 520A A1 02-37 or earlier
CB 540A A1/B1 03-19 or earlier
Go to Restoring the iSCSI settings on page 7-81.
Restoring the iSCSI settings
This procedure shall be performed when the firmware version of management
module is A0179 or earlier, or the firmware version of server blade is as
follows.
When the server blade is CB 520H B2/B3/B4 or CB 520X B1/B2/B3, skip the
following procedure.
Server model Firmware version
CB 520H A1/B1 01-69 or earlier
CB 520A A1 02-37 or earlier
CB 540A A1/B1 03-19 or earlier
1. Click Power and select Power On in Remote console menu.
2. Power Control dialog box is displayed. Click Yes.
The target server blade is powered on.
Configuring Emulex mezzanine card
7-81
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
