Replacing an SFP+ module
This procedure describes how to replace an SFP+ module or SFP+ copper
cable.
CAUTION:
The device contains a laser that is classified as a Class 1 Laser Product.
Do not look directly at the laser beam.
Removing an SFP+ module
SFP+ module for LAN switch/8Gb FC switch/DCB switch/LAN pass trough
1. Put on an anti-static wrist strap.
2. Connect Web console. See Web console login procedure on page 4-3
section.
3. Turn on LID LED for identifying the target module.
See
Identify LED (LID) on/off procedure on page 4-7 section.
4. Turn on the maintenance mode from web console.
See
Maintenance mode on/off procedure on page 4-10 section.
5. Remove a cable from the failed FC port.
6. Release the lever shown as below.
7. Hold the released lever and pull it toward you.
Figure 5-144 Removing an SFP+ module
SFP+ module for 16Gb FC switch
1. Put on an anti-static wrist strap.
2. Connect Web console. See Web console login procedure on page 4-3
section.
3. Turn on LID LED for identifying the target module.
See
Identify LED (LID) on/off procedure on page 4-7 section.
4. Turn on the maintenance mode from web console.
5-114
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
