Figure 5-90 Installing the PCI card cage
Replacing a mezzanine card in the PCI expansion blade
This procedure describes how to remove a mezzanine card in the PCI
expansion blade.
Removing a mezzanine card
1. Put on an anti-static wrist strap.
2. Record the parameters in the case of replacing Emulex HBA card.
See Configuration procedure for Emulex HBA card on page 7-2 section.
3. Remove the target PCI expansion blade.
Replacing parts
5-73
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
