Hitachi CB 520H B1 - Updating Firmware on Switch Module

Figure 9-4 Start the updated firmware
Note: If the only dictionary file and parameter file are updated, the
management module does not reboot. Only when the management module
firmware is updated, the management module will reboot.
Note: Do not power off the management module and disconnect the LAN
cable during updating the firmware.
Updating firmware on switch module
Tip: Before performing the following procedures, you must download the
updated firmware file from Hitachi Data System support portal to the console
PC.
1Gb LAN switch module or 1/10Gb LAN switch module
1. Click Start > Programs > Accessories > Communications >
HyperTerminal to boot up terminal software.
Updating firmware
9-5
Hitachi Compute Blade 500 Series System Service Manual