Go to Confirming the iSCSI settings on page 7-57.
Confirming the iSCSI settings
This procedure shall be performed when the firmware version of management
module is A0179 or earlier, or the firmware version of server blade is as
follows.
When the server blade is CB 520H B2/B3/B4 or CB 520X B1/B2/B3, skip this
procedure.
Server model Firmware version
CB 520H A1/B1 01-69 or earlier
CB 520A A1 02-37 or earlier
CB 540A A1/B1 03-19 or earlier
1. Click Power and select Power On in Remote console menu.
2. Power Control dialog box is displayed, Click YES.
The target serve blade will power on.
3. Press Ctrl + P key when the following prompt was displayed.
4. PXESelection Utility window is displayed. Select the target controller,
and then press Enter key.
Configuring Emulex mezzanine card
7-57
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
