13. Remove the USB memory.
Figure 5-152 Removing a USB memory
Installing a USB memory
1. Put on an anti-static wrist strap.
2. Reverse the removal procedure.
3. Turn off LID LED for identifying the target module.
See Identify LED (LID) on/off procedure on page 4-7 section.
4. Turn off the maintenance mode from web console.
See
Maintenance mode on/off procedure on page 4-10 section.
Replacing a power supply module
This procedure describes how to replace a power supply.
WARNING:
To prevent the risk of electrical shock, disconnect power cord before
removing power supply module.
CAUTION:
High temperature component.
Do not touch the power supply module after removing the power cord.
Wait 5 or more minutes before holding the power supply module to
reduce the risk of serious burn injuries from hot surfaces.
Replacing parts
5-121
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
