Hitachi CB 520H B1 - Installing a DIMM

Figure 5-50 Removing the USB enablement kit and air duct- CB
520H A1/B1/B2/B3/B4
6. Open the DIMM socket ejector tabs and remove the DIMM from the DIMM
socket.
Figure 5-51 Removing the DIMM
Installing a DIMM
1. Put on an anti-static wrist strap.
2. Ensure that the DIMM socket ejector tabs are in the open position.
3. Line up the spare DIMM with the socket.
4. Push the spare DIMM into the socket until the ejector tabs lock the DIMM
in place.
5. Ensure that the DIMM socket ejector tabs are in the close position.
Replacing parts
5-43
Hitachi Compute Blade 500 Series System Service Manual