Figure 5-141 Removing the lithium battery
WARNING: To reduce the risk of the personal injury, do not attempt to
recharge the battery and do not crush, puncture or dispose of in fire.
CAUTION: Do not dispose the battery along with general household
waste. Use a public collection system, or return it to the Hitachi Data System
Support for recycling or proper disposal.
Installing a lithium battery
1. Put on an anti-static wrist strap.
2. Reverse the removal procedure.
3. Install the target management module. See Replacing a management
module (redundant) on page 5-100 or Replacing a management module
(non-redundant) on page 5-106.
Note: Replacing the lithium battery in the management module results the
RTC clock initializes to default time. After replacing the battery, perform the
TOD process absolutely. For details, see
Time of Day (TOD) clock setup
procedure on page 4-44.
Replacing a switch module
This procedure describes how to replace a switch module.
Removing a switch module
Notice:
Be sure that the redirected network is active or the critical network has
stopped to avoid important data loss before removing the switch module.
5-110
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
