< IP address >:IP address for the target switch module. See Internal IP
address setup procedure for switch module on page 4-18 section.
4. The login prompt is displayed in the terminal.
Figure 4-37 Connecting to 10Gb DCB switch module
5. Enter admin as login name, and then press Enter key.
6. Enter password as password, and then press Enter key.
7. Confirm that the command prompt is indicated.
8. Enter copy startup-config ftp://upload:password@< IP Address
for console PC >/<backup data file name >, and then press Enter
key.
4-42
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
