Select Resources tab and select Modules > Server Blades > a target
blade that should update the FRU information.
[For SMP CB 520X B1/B2/B3]
Select Resources tab and select Modules > Server Blades > Server
Blade n of the SMP configuration > a target blade that should
update the FRU information.
2. Select Hardware tab.
3. Click Show FRU/Sensor.
4. The FRU/Sensor Information dialog box is displayed, click Edit > LOM
Type.
5. The Edit LOM type dialog box is displayed, select 0x02, and click
Confirm.
6. The Confirm dialog box is displayed, and then click OK.
7. After the FRU update process has completed, the FRU/Sensor
Information dialog box is displayed again. Confirm that LOM type field is
0x02.
Change LOM configuration
10-9
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
