Hitachi DKC910I - Page 198

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)14-02-130]
Rev.1
INST(IN)14-02-130
(9) Response to the message “[4279] This operation requires the storage system running in the CE
mode. Check status of the storage system.
Select [Yes] when the storage system is already running in the CE mode.
Select [No] when the storage system is not running in the CE mode or if you execute without a
switch setting of the CE mode.”.
When [Yes] is clicked, go to Step (10).
When [No] is clicked, go to Step (11).
(10) Click [Yes] or [No] in response to the message [INS4466i].
• When all CTLs are displayed:
Click [Yes] and go to Step (11).
• When some CTLs are not displayed or when none of CTLs are displayed:
Click [No] to terminate the processing. Wait for 20 minutes, and then retry the new installation
procedure from Step (3).