Hitachi DKC910I - Page 199

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)14-02-140]
Rev.7
INST(IN)14-02-140
(11) Select the drive
The message [CNF3683i] is displayed.
Select the Maintenance PC drive into which the micro-program media is inserted, and then click
[OK].
(12) Make a copy of the conguration information.
During the copying, the CNFCPY Wait... window is displayed.
(13) After removing the media (*1) by responding to the message “[3188] The processing is complete.
Remove the media of the conguration information if necessary.”, click [OK] .
*1: A micro-program is initialized using the conguration information in the media in this
procedure.