Hitachi DKC910I - Page 200

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)14-02-150]
Rev.0
INST(IN)14-02-150
(14) Click [OK] in response to the conrmation message “[2565] Installation data of program product
in the Conguration table will be initialized by this operation. After nishing this procedure, please
set the program product installation again.”.
NOTE: When information of DP-VOL implementation or progressing status of quick format
is not included, go to Step (15).
(15) <DKC Conguration window>
NOTE: Check the nameplate of the Storage System, and then enter the serial number.
When the DKC Conguration window is displayed, enter the serial number.
Click [>>Next] .
This procedure is completed when [Cancel] is clicked.
(16) Set the current date and time on which New Installation is performed in the Set Machine Install
Date window, and then click [OK] .