Hitachi DKC910I - Page 37

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)03-01-60]
Rev.2
INST(IN)03-01-60
2. Installing rails for Drive Box (SBX/UBX)
The rail install procedure is different depending on the hole shape (square or circular hole) on the rack.
Check the holes on the rack before the installation work.
Table 3-2 shows the components for the rails for Drive Box (SBX/UBX).
Table 3-2 Components for Rail (RRDB) (Per Unit)
Item No. Part Name Part No. Quantity Comment Remarks
1 Slide Rail 2853847-C 1 set Rail
×
2
−
2 Screw (SBB-RAIL)
−
4
−
(*1)
3 Pin Screw
−
4
Pin for circular hole
(*1)
4 Loop cable tie 5552567-1 2 For xing the cable
−
*1 : These parts are included in Slide Rail (Item No.1).