Hitachi DKC910I - Page 83

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)07-02-20]
Rev.2
INST(IN)07-02-20
1. Fixing the front side of the Drive Box
NOTE : Use parts of the rail for the xing screw and other products. (Refer to Table 3-2.)
(1) Install the Drive Box on the front side of the Rack frame.
(2) For SBX/UBX
From the rear of the rack, check whether the nuts (stoppers) t the parts of the Drive Box as shown
in the gure below.
If the positions of the nuts (stoppers) are not correct, remove the Drive Box, and correct the
positions of them.
For NBX
From the rear of the rack, check whether the stoppers t the parts of the Drive Box as shown in the
gure below.
If the positions of the stoppers are not correct, remove the Drive Box, and reinstall it in the correct
position. (The stopper of the rail for NBX is xed to the rail and is not adjustable.)
Figure 7-5 Checking the Rear Side of the Drive Box
Nut (stopper)
Nut (stopper)
Rail
Rear view of SBX/UBX
Rail
Rear view
Rail
Rear view of SBX/UBX
Rail
Stopper
Rear view of NBX