Hitachi DS240 - Page 81

INSTALLING THE HARDWARE INSTALLING A PROCESSOR
2-39
10. Turn the heat sink over and locate the corner chamfer. This is the corner that must
be aligned over the PIN1 indicator on the bracket assembly.
11. Align the following:
 Corner chamfer on the heat sink and the PIN1 indicator on the bracket assembly.
 Four retention clips over the four heat sink corners.
 Make sure the airflow indicator is pointing towards the hot side of the system.
Figure 2-47. Installing a Heat Sink
Note:
Make sure the PIN1 indicator on the bracket is aligned with the PIN1 indicator on the
processor before placing the bracket on the processor.
Note:
Make sure the processor and the bracket are in the tray before you install the heat sink.
PUSH
Chamfer
PIN1
Indicator