the interface is started up. Be careful because, if this action executes the ping6 a
traceroute6 commands to the IPv6 address for which duplication has been identi
with other devices, a response may be returned from the IPv6 address of another
interface in the device, rather than from the IPv6 address designated as the
destination.
In addition, because the duplicated address detection is not completed for a few
seconds immediately after the interface start-up, a response may similarly be
returned from another IPv6 address. However, the operation returns to normal a
soon as the duplicated address detection has been completed, hence causing no
problem.
4.9.1.6 IPv6 function that can be used at IPv6 relaying software processing
This device performs the IPv6 relaying software processing or the IPv6 relaying
hardware processing depending on the type of mounted RP. At the IPv6 relaying
software processing, the usable IPv6 function is limited when compared to the IP
relaying hardware processing. If all the IPv6 functions in this device are used, it
recommended to mount an RP so that the IPv6 relaying software processing is
performed. Table 30-31: List of IPv6 function supports by software processing sho
To Next Page
Loading...
Need help?
General
