Product Overview
GR2K-GA-1002 2-33
Rev 6.03
RP-D6 GR2000 IPv6 compatible
Has RP-D function
IPv6, IPv4 dual stack
Packet transfer rate: 1.0Mpps (IPv4)
(Full duplex)0.8Mpps (IPv6)
MS = 128MB (standard) - 256MB (max)
• Packet transfer engine is used commonly for transmission and reception.
• Routing retrieval engine is used commonly for transmission and reception.
• The mounted processor is MIPS RM7000 |250Mhz|.
GR2000-2S: Not
mountable
RP-C6 RP-C6 is a routing processor to which the hardware routing function of IPv6 has
been enhanced on RP-C to accommodate high-speed lines such as OC-48c and the
gigabit Ethernet of multi-port versions. Its hardware configuration is as follows:
• The packet transfer engines are exclusively mounted for transmission and
reception.
• The routing retrieval engines are exclusively mounted for transmission and
reception.
• The mounted processor is MIPS RM7000 "250 MHz".
• A memory of 128 M bytes is mounted in a fixed way.
RP-CV RP-CV is a routing processor to which the hardware routing function of IPv6 has
been enhanced on RP-C to accommodate high-speed lines such as OC-48c and the
gigabit Ethernet of multi-port versions. Its hardware configuration is as follows:
• The packet transfer engines are exclusively mounted for transmission and
reception.
• The routing retrieval engines are exclusively mounted for transmission and
reception.
• The mounted processor is MIPS RM7000 "250 MHz".
• A memory of 128 M bytes is mounted in a fixed way.
(*1) For the GR2000-10/20, there are some limitations on installation of RP-C boards and NIF modules supporting
them. For more information, see "adding enhanced features" in Section 7.1.1.
(*2) The MPLS or MPLS-based IP-VPN feature is not available for the GR2000-2S/4S.
Table 2-4 RP Specifications
RP name Specification Note
To Next Page
Loading...
