Hitachi SVP F 00 Series - Uploading the Signed Server Certificate of the SSL Communication Between the SVP and Client PC

3. Enter an arbitr
ary password. This password is used when uploading the SSL
certicate in the PKCS#12 format to the storage system. The characters used for the
password when creating the SSL certicate in the PKCS#12 format are shown as
follows. and specied by the character string of 128 characters or less: A-Z a-z 0-9 ! #
$ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ `{ | } ~
The client.p12 le is created in the C:\key folder. This le is the SSC certicate
converted into the PKCS#12 format.
4. Close the command prompt.
Uploading the signed server certificate of the SSL
communication between the SVP and client PC
Upload the private key and the signed server certicate (public key) to the SVP for using
an arbitrary certicate for SSL communications between the SVP and client PC.
The following describes how to upload the certicate using the certicate update tool.
This procedure assumes that:
■
A private key (server.key le) has been created. Change the le name to
server.key unless the le already uses that name.
■
A signed public key certicate (server.crt le) has been acquired. Change the le
name to server.crt unless the le already has that name.
■
All users are logged out of Device Manager - Storage Navigator.
Procedure
1. On the SVP, start a Windows command prompt as Administrator.
2. Move the current directory to the directory where the certicate update tool
(MappApacheCrtUpdate.bat) is located. Issue the following command: C:\MAPP
\wk\Supervisor\MappIniSet\ MappApacheCrtUpdate.bat r[absolute
path of the certificate file] r[absolute path of the private key
file].
Note: C:\MAPP indicates the installation directory of the SVP. If you
specify an installation directory other than C:\Mapp, replace C:\Mapp
with the specied installation directory.
3. At the message Press any key to continue the process…, enter an arbitr
ary
key.
4. Close the command prompt.
Returning the certificate of the SSL communication between
the SVP and the client PC to the default
This procedure requires all users to log out of Device Manager - Storage Navigator.
Uploading the signed server certicate of the SSL communication between the SVP and client PC
Chapter 11: Setting up SSL encryption
Service Processor Technical Reference 204