Hitachi SVP F 00 Series - Initializing SVP Port Numbers

■ Multiple command input par
ameters "[Port Number Key] _ [Port
Number]" can be specied. The _ character indicates a space. For example:
MappSetPortEdit.bat MAPPWebServer 81 MAPPWebServerHttps 444
■ A management le of the port numbers used in the SVP follo
ws. For example:
The management le of the port numbers is for reference only and should not
be changed. Close the management le of the port numbers when issuing the
change (initialization) command.
<The directory where the tool exists>\mpprt\cn
\mappsetportset.properties
C:\Mapp\wk\Supervisor\mappiniset\mpprt\cnf
\mappsetportset.properties
■ V
erify the port numbers to be used in the SVP. See
Viewing the port number to
be used in the SVP (on page 225) .
■ The completion message is displayed follo
wing the service restart message.
■ The port number key name is case sensitive.
5. A service restart message appears followed by a completion message.
6. At the message Press any key to continue, press any key to continue.
7. Exit from the command prompt.
Initializing SVP port numbers
You can reset SVP port numbers to their initial setting. Resetting the port numbers
restarts the SVP. To initialize the automatically allocated port numbers, see
Initializing
automatically allocated port numbers (on page 222) .
Befor
e you begin
■
Connect the management console PC to the SVP.
■
Verify the client PC is already connected to the SVP using Remote Desktop
Connection.
■
Verify that you are logged out of HDvM - SN.
Procedure
1. On the SVP, exit to a Windows command prompt as Administrator.
Initializing SVP port numbers
Chapter 14: Changing and initializing SVP port numbers
Service Processor Technical Reference 218