Hitachi SVP F 00 Series - Restoring the SVP Configuration

6. Exit the command pr
ompt.
7. Move the conguration le from the SVP to a USB ash drive.
Note: Do not edit the contents of the backup le.
Restoring the SVP configuration
If you back
ed up the SVP conguration, you can use the following procedure to restore
the conguration. This procedure is particularly useful when you receive a replacement
SVP and want to install a conguration that was used on your previous SVP.
Before you begin
■
Verify the client PC is connected to the SVP through a Remote Desktop Connection.
■
Check the storage system you want to restore is registered on the SVP.
■
Congure the service setting to not start automatically when the SVP restarts.
Procedure
1. Copy the backup le to a folder on the SVP.
2. On the SVP, exit to a Windows command prompt as Administrator.
3. Move to the directory where the backup le exists, and then issue the following
command:
C:\MAPP\wk\Supervisor\MappIniSet\MappRestore.bat[absolute path of the
b
ackup (tgz zip) file]
Note: In this command, C:\MAPP indicates the installation directory of
the SVP. If the installation directory is dierent, replace C:\MAPP with the
specied installation directory.
4. At the r
estoration message, press any key to continue.
5. Congure the service setting that you want to start automatically the next time the
SVP restarts (see Changing storage system information in the Storage Device List).
6. Restart the SVP. Wait approximately 10 minutes for the restart to complete.
Restoring the SVP congur
ation
Chapter 17: Back up and restore the SVP
Service Processor Technical Reference 249