Hitachi SVP F 00 Series - Uploading the Certificate to the Web Server; Returning the Web Server Certificate to the Default

Uploading the certificate to the web server
Execute the SSL communication with Device Manager - Storage Navigator installed on
the SVP as a client and the controller of the storage system as a server. Upload the
private key and the signed server certicate (public key) to the SVP for using the SSL
communication. The following describes how to upload the certicate using the
certicate update tool.
This procedure assumes that:
■
The private key of the storage system and the signed server certicate (public key) for
the web server from the maintenance utility have been updated.
■
The private key (server.key le) and the signed public key certicate (server.crt
le) are in X.509 PEM or X.509 DER format.
■
All users are logged out of Device Manager - Storage Navigator.
Procedure
1. On the SVP, start a Windows command prompt as Administrator.
2. Move the current directory to the directory where the certicate update tool
(MappSn2GumSslCrtUpdate.bat) is located. Issue the following command:
C:\MAPP\wk\Supervisor\MappIniSet\ MappSn2GumSslCrtUpdate.bat
r[absolute path of the certificate file]
Note: C:\MAPP indicates the installation dir
ectory of the SVP. If you
specify an installation directory other than C:\Mapp, replace C:\Mapp
with the specied installation directory.
3. At the message Press any key to continue the process…, enter an arbitr
ary
key.
4. Close the command prompt.
Returning the web server certificate to the default
If necessary, you can revert to the default web server certicate.
This procedure assumes that:
■
The private key (server.key le) and the signed public key certicate (server.crt
le) are in X.509 PEM or X.509 DER format.
■
All users are logged out of Device Manager - Storage Navigator.
Procedure
1. On the SVP, start a Windows command prompt as Administrator.
2. Move the current directory to the directory where the certicate update tool
(MappSn2GumSslCrtInit.bat) is located. Issue the following command: C:\MAPP
\wk\Supervisor\MappIniSet\MappSn2GumSslCrtInit.bat
Uploading the certicate to the web server
Chapter 11: Setting up SSL encryption
Service Processor Technical Reference 206