4. V
erify that all four SVP LAN adapters are recognized, but disconnected, and that the
local-area connection numbers are assigned as 5, 6, 7, and 8.
5. Connect an Ethernet cable to the LAN1 port on the SVP
.
Local Area Connection 7 is assigned to the LAN1 port.
6. Remo
ve the Ethernet cable from the LAN1 port and connect it to the LAN2 port on
the SVP.
Local Area Connection 6 is assigned to the LAN2 port.
7. Repeat step 6 with the LAN3 and LAN4 ports on the SVP
.
When you connect the Ethernet cable to these ports, Local Area Connection 8 will
be assigned to the LAN3 port and Local Area Connection 5 will be assigned to the
LAN4 port.
Note: V
erify that no IP address is conī “gured for the SVP LAN ports.
Otherwise, the storage system could become blocked.
Renaming the internal SVP network adapters
Renaming the internal SVP network adapters
Chapter 19: Replacing the Hitachi Vantara-supplied SVP
Service Processor Technical Reference 254
To Next Page
Loading...
