Hitachi SVP F 00 Series - Behavior When Changing SVP Port Numbers

2. Change to the dir
ectory where the tool MappSetPortEdit.bat is located, and then
issue the following command: C:\Mapp\wk\Supervisor\MappIniSet
\MappSetPortEdit.bat
Tip: In this command, C:\MAPP
indicates the installation directory of the
storage management software and SVP software. If the installation
directory is not C:\Mapp, replace C:\Mapp with the appropriate
installation directory.
A conrmation message appears.
3. Enter y and pr
ess Enter.
A service restart message appears followed by a completion message.
4. At the message Press any key to continue, press any key to continue.
5. Exit from the command prompt.
Behavior when changing SVP port numbers
If you change an SVP port number, observe the following considerations.
Port number key name Eect
MAPPWebServer Using Hitachi Device Manager - Storage
Navigator
The URL specication method to log on to
Stor
age Navigator changes.
Using Hitachi Command Suite
Match the port number used in Hitachi
Command Suite to <SVP Change Port>.
MAPPWebServerHttps Using Hitachi Device Manager - Storage
Navigator: None
Using Hitachi Command Suite
Match the port number used in Hitachi
Command Suite to <SVP Change Port>.
RMIClassLoader None
RMIClassLoader Using Hitachi Command Suite
Match the port number used in Hitachi
Command Suite to <SVP Change Port>.
Behavior when changing SVP port numbers
Chapter 14: Changing and initializing SVP port numbers
Service Processor Technical Reference 219