Hitachi SVP F 00 Series - Registering the Storage System on the SVP

Registering the storage system on the SVP
If you delete the r
egistered storage system from the SVP, you can register the storage
system.
Before you begin
■
Verify the to-be-registered storage system is operating, and the IP addresses of the
SVP and the storage system are using the same subnet.
■
Upgrade the rmware for the storage system being registered.
This procedure takes approximately 10 minutes for each storage system to be registered
and approximately 200 minutes for each storage system that needs a rmware upgrade.
Note: The upgr
ade time can take up to 9 hours to complete when NAS
modules are installed.
Procedure
1. At the console PC connected to the physical SVP or running the SVP software, insert
the media containing the SVP rmware media.
2. On the SVP, create a new folder, and then copy all of the les from the SVP rmware
media into the new folder.
3. In the new folder, right-click the Setup.exe le and click Execute as
Administrator.
Registering the storage system on the SVP
Chapter 16: Deleting and registering the storage system
Service Processor Technical Reference 237