Hitachi SVP F 00 Series - Page 220

RMIClassLoaderHttps Using Hitachi De
vice Manager - Storage
Navigator
When using the raidinf command (a
program for obtaining conguration
reports and obtaining tier relocation logs)
to log on to Device Manager - Storage
Navigator, specify <SVP Change Port> in
addition to the SVP IP address or host
name.
RMIIFRegist When issuing the remote power ON/OFF
tool (RmtPsT
ool) command, specify <SVP
Change Port> for the Management Server
Port Number parameter.
When issuing the export tool command,
specify <SVP Change Port> in addition to
the SVP IP address using ip Subcommand
to the SVP IP address.
Using Hitachi Command Suite
Match the port number used in Hitachi
Command Suite to the new SVP port.
PreRMIServer None
DKCManPrivate None
SMI-S (SLP) Using SMI-S:
Match the port number used in the SMI-S
communication to <SVP Change Port>.
SMIS_CIMOM Match the port number used in the SMI-S
communication to <SVP Change Port>.
For a storage system running rmware
version 83-03-01-xx/00 or later, register
the storage system, and then set it after
verifying the port numbers to be used
(see
Viewing the port number to be used
in the SVP (on page 225) )
CommonJettyStart None
CommonJettyStop None
RestAPIServerStop None
DeviceJettyStart None
DeviceJettyStop None
Behavior when changing SVP port numbers
Chapter 14: Changing and initializing SVP port numbers
Service Processor Technical Reference 220