Hitachi SVP F 00 Series - Page 224

Note:
Port number k
ey name and Default value of port number range can
be changed as shown in the following table. Zero number port is not
allocated regardless of this command setting.
Port Number Key
Name
Default value of port
number range Comments
PreRMIServer 51100 to 51355 -
SMIS_CIMOM 5989 to 6244 -
DeviceJettyStart 48081 to 48336 -
DeviceJettyStop 48411 to 48666 -
N/A 1 to 1023 Port numbers that
ar
e not used by
automatic allocation
■ The eective r
ange of the port number range is 1 to 65535. Set the
port numbers so as to avoid conict with those used in other
services.
■ Port numbers 1 to 1023 are reserved in other applications. If 1 to
1023 are excluded from the unavailable setting value, the applications
might not operate normally.
■ The available character strings in the eective range are as follows:
"Number" "," "-" "rm"
If "rm" is specied, delete the setting of the specied port number
key.
■ You can specify more than one command input parameter “[Service
port number key name] * [Port number range] where * is a one-byte
space.
For example, MappPortRangeSet.bat PreRMIServer
51200-55000 SMIS_CIMOM 5989-6244,8000
■ The port number range set for unavailable cannot be used, even if it
is an eective range for other keys.
For example, when PreRMIServer 51100-51355 unavailable
51100-51200 is set, the port number range allocated by PreRMIServer
is 51201 to 51355.
3. A completion message appears. Pr
ess any key to continue.
4. Close the command prompt.
Changing range of port numbers to be allocated automatically
Chapter 14: Changing and initializing SVP port numbers
Service Processor Technical Reference 224