Hitachi SVP F 00 Series - Page 243

11. T
o update the rmware of the storage system being registered, check Firmware
(Storage System). Otherwise, leave it unchecked.
12. To register additional storage systems, repeat steps 6 through 10.
13. Click Apply in the target storage system list window.
14. T
o upgrade the rmware, click Conrm when the Update software and rmware
window opens.
The Run Update Firmware window opens and the upgrade starts automatically.
15. When the following screen opens, use the status bar under the Software (Storage
Navigator) column to monitor the update status. The following table lists the status
conditions.
Registering the storage system on the SVP
Chapter 16: Deleting and registering the storage system
Service Processor Technical Reference 243