18. Click OK.
19. W
ait for the rmware upgrade to complete, and then verify the rmware update
status in the Firmware (Storage System) column of the Environmental Settings
window. Wait for the rmware update to complete. The following table lists the
status conditions.
Status Description
(Select Update) Click Update to display the Update
Firmwar
e window.
In progress The Update Firmware window started
and the rmware upgrade is not
complete. This status appears even if
the rmware upgrade is canceled.
Completed Firmware upgrade is complete.
Failed Firmware upgrade failed. Click Update
to display the Update Firmware
window, and review the error details.
Communication Timeout The time
1
required to complete the
rmware upgrade cannot be conrmed.
Verify the state in the Update
Firmware window.
(Not Update) Not selected as a rmware upgrade
target.
Note:
1. When NAS Modules are not installed, the installation time is approximately 3.5
hours. When NAS modules are installed, the installation time is approximately 9
hours.
20. When the rmwar
e upgrade completes, click Close.
Registering the storage system on the SVP
Chapter 16: Deleting and registering the storage system
Service Processor Technical Reference 246
To Next Page
Loading...
