9. When the follo
wing completion message appears, perform one of the following
steps:
■ To continue, click The setting has been completed. I will continue installation
and updating of the software.
■ To set port numbers, rewall settings, and anti-virus software, click The setting
is not completed. I will install and update the software after I complete the
setting.
10. Click Finish.
11. At the Envir
onmental Settings window, click IPv4 or IPv6, and then enter the IP
address of the SVP and click Apply.
Installing Hitachi Device Manager - Storage Navigator
Chapter 19: Replacing the Hitachi Vantara-supplied SVP
Service Processor Technical Reference 270
To Next Page
Loading...
