● Do not insert tweezers, a screwdriver, or any other metal article into the ink ejection hole at the
end of the print head.
When the product is ready to print, a high voltage (approximately 6 kV) is applied to the
deflection electrode section in the print head.
Exercise caution to avoid electric shock, injury, and fire.
● Do not remove covers and/or screws not specified in this manual.
A high voltage is applied to some sections of the product.
Exercise caution to avoid electric shock and injury.
● While the product is operating, do not look into the ink ejection hole at the end of the print head.
Ink or makeup may enter your eyes or mouth or soil your hands or clothing. If any ink or
makeup enters your eyes or mouth, immediately flush with warm or cold water and consult a
physician.
● Before servicing the product, be sure to stop the ink ejection.
This is because ink or makeup may splash into your eyes or mouth or onto your hands or
clothing.
If any ink or makeup enters your eyes or mouth, immediately flush with warm or cold water and
consult a physician.
● If an earthquake, fire, or other emergency occurs while the printer is engaged in printing or just
turned on, press the main power switch to turn off the power.
Do not perform this operation in any other situation than emergency.
● Only people who have completed an operator training course for Hitachi can operate and
service the product.
- If the printer is operated or serviced incorrectly, it may malfunction or break down.
● Do not attempt to repair the product for any other purpose than operation or maintenance.
Otherwise, it may cause a malfunction, so if a repair is needed, contact your nearest local
distributor.
To Next Page
Loading...
