(3) Operation
The following shows how to set I and Q in [Count skip] for printing with alphabet letters I and Q skipped.
[Note]
● When a count character is added, overwritten, or deleted, the [Changed Skip condition] confirmation
message appears on the screen, making count skip characters invalid.
● Input one of the following three types in [Range] (max.): Uppercase alphabet characters, lowercase
alphabet characters, or user patterns. If [Range] (max.) is not all the same, all count skip characters must
be included in the smallest range.
● Characters used in [Value], [Range], [Jump], and [Reset] cannot be input in [Count skip].
● When [Count skip] is set, an incremental value is always 1.
Input Count.
Count input screen (printing count skip characters)
Press Count conditions.
The [Count conditions] screen appears.
Press
or
in the print description edit area to change the target count block.
To Next Page
Loading...
