Hitachi UX2 - 9.2. Setting Date and Time

Chapter 9. Environment Setup
9-10
9.2. Setting Date and Time
This section describes how to set the date and time.
(1) Functions
● Sets the date and time values.
Date/time setup item list
Setting item
Description
Default
Current time
● Sets the current date and time (clock function).
–
Calendar time control
● Selects whether to use or stop using the current date
and time as the calendar time.
same as
current time
● Sets the time displayed in the clock
at the upper-right corner of the
screen as the calendar time.
clock stop
● Sets a specified time as the calendar
time.
● The clock (current time) at the
upper-right corner of the screen is
not stopped.
● The value must be no later than the
current date and time.
same as
current time
Calendar time
● Sets the calendar time.
● The print description of calendar characters is based
on [Calendar time] instead of [Current time].
● This can be set only when [Calendar time control] is
[clock stop].
–
Clock system
● Sets the 24-hour clock or 12-hour clock.
24-hour clock
00.00 to 23:59
12-hour clock
A.M. 00:00 to 11:59
P.M. 00.00 to 11:59
24-hour
clock
[Note] When the substitution rule is set to the "year", do not select [clock stop] and set a year earlier
than the current year. Otherwise, the "year" is replaced by a space.