Hitachi UX2 - 10.2. Checking Operational Status

Chapter 10. Environment Setup
10-4
10.2. Checking Operational Status
This section describes how to check the operational status.
(1) Functions
● Displays the operational status of the IJ printer.
● Saves the ink operating time and print count once an hour (on the first minute of every hour).
When there is a power failure, the last saved state is restored.
● The ink operating time, print count, and ink pressure are also displayed on the [HOME] (initial) screen.
Operational status check items
Item
Description
Ink operating time
(editable)
● Displays the operating time that has elapsed since the last ink replacement.
● It is reset to "0" at ink replacement. Up to 9,999 hours can be displayed.
● When the operating time exceeds [Ink alarm time], the ink replacement
warning message appears.
Ink alarm time
● Displays the recommended ink replacement time.
● The standard value is always displayed.
Cumulative op. time
● Displays the cumulative operating time. This value cannot be changed.
● Up to 999,999 hours can be displayed.
Print count (editable)
● Displays the number of prints.
● The value range is from 0 to 999,999,999.
Ink type
● Displays the type of ink used.
Makeup type
● Displays the type of makeup used.
Ink viscosity
● Displays the ink viscosity.
● The standard value is 100.
Ink pressure
● Displays the ink pressure.
● The standard value is always displayed.
Ambient temperature
● Displays the ambient temperature and the allowable ambient temperature.
Deflection voltage
● Displays the deflection voltage in the [Ready] state.
Excitation V-ref.
● Displays the set excitation V-ref. value.