Chapter 11. Safe Clean Station
11-12
Remove the print head from the cleaning station and make sure that the area around the nozzle including
the end of the print head is cleaned and the makeup is dried up.
Print head end surface, nozzle periphery
● The ink stain may remain or the head is not dried enough depending on the ink stain level or
operating environment.
● After cleaning, wipe off the print head with wiping paper if it is wet.
● If the print head is stained after cleaning, perform head cleaning again or clean the print head
using a cleaning bottle.
● If the ink does not come off easily, wipe it off with wiping paper soaked in makeup.
● Do not apply excessive force to the electrode when wiping. Otherwise, it may deform, causing
an unexpected malfunction.
To Next Page
Loading...
