Hitachi UX2 - 11.3. Starting Operation Using Cleaning station

Chapter 11. Safe Clean Station
11-14
11.3. Starting Operation Using Cleaning station
This section describes how to start operation using the cleaning station ([Eject ink (S)] operation procedure).
If a fault is detected during [Eject ink (S)] process, the nozzle is automatically cleaned and ink ejection starts
again.
● Operation procedure
Make sure that the unit is in the [Stop] state.
[HOME] screen (unit state)
Remove the print head cover and check whether or not the print head cover and nozzle periphery are
soiled by ink.
Print head cover and nozzle periphery (checking for stain)
Since this unit prints by ejecting ink against the print material, the outside and inside of the print head
cover are soiled by splashing of the ink from the print material. To prevent printing problems due to
soiling, check the soiling state and clean the unit where necessary.
See "11.2. Head Cleaning Using Cleaning Station" for how to clean the head.
1
Status:
Shows the state of the unit.
2
Nozzle periphery
Loosen the screw
Pull out
Print head cover