Hitachi UX2 - Page 295

Chapter 13. Troubleshooting Guide
13-3
Chapter 13.
Troubleshooting guide (Continued)
Symptom
Check item
Solution
[Print Overlap Fault]
occurs frequently.
● See "Chapter 12. When Warning or Fault Occurs".
A fault message is
displayed.
The after-image of
characters remains on the
screen.
-
● Due to the characteristics of the LCD
panel, when the same pattern is kept
displayed for a long time, the after-image
of the pattern may remain but will
disappear over time.
The RFID cannot be
read.
-
● The tag may be broken. Manually input
the ID according to "Chapter 8. Ink and
Makeup Replenishment".
The cartridge cannot be
replaced because it is not
unlocked.
-
● Push the lever into the equipment.
[Note]
If the above action does not solve the problem, stop using the unit. Then, disconnect the power plug from the
power outlet and contact your Hitachi distributor.
■ Necessary information
* The model number and serial number are written on the nameplate attached to the right-hand side of the unit.
1. TYPE-FORM (model number):
________
IJ printer (UX2-□□□□□□)
2. SER. No. (serial number):
___________
UX2□□□□□□□□
3. Failure description:
_________________
Be as specific as possible.
4. Organization name (department and section names included), name of
person in charge, and phone number